Cerca
Ara mostrant els elements 11-20 de 68
Influence of implant design and under-preparation of the implant site on implant primary stability: an In vitro study
(MDPI, 2020)
The aim of this study was to evaluate the effects of different implant sites an under-preparation sequence associated with two different implant designs on implant primary stability measured by two ...
Fabrication and deposition of copper and copper oxide nanoparticles by laser ablation in open air
(MDPI, 2020-02-10)
The proximity of the “post-antibiotic era”, where infections and minor injuries could be a cause of death, there are urges to seek an alternative for the cure of infectious diseases. Copper nanoparticles ...
Impedimetric antimicrobial peptide-based sensor for the early detection of periodontopathogenic bacteria
(Springer Nature, 2016)
Novel researches are focused on the prevention and management of post-operative infections. To avoid this common complication of implant surgery, it is preferable to use new biomaterials with antibacterial ...
Relevant aspects of piranha passivation in Ti6Al4V alloy dental meshes
(MDPI, 2022)
Passivation of titanium alloy dental meshes cleans their surface and forms a thin layer of protective oxide (TiO2) on the surface of the material to improve resistance to corrosion and prevent release ...
Influence of bone-level dental implants placement and of cortical thickness on osseointegration: in silico and In vivo analyses
(MDPI, 2022)
The purpose of this research is to study the biomechanical response of dental implants in bone-level type locations, 0.5 mm above and below the bone level. In addition, the influence of the thickness ...
Fatigue of narrow dental implants: influence of the hardening method
(MDPI, 2020)
The use of narrow titanium dental implants (NDI) for small ridges, reduced interdental space, or missing lateral incisors can be a viable option when compared to the conventional wider dental implants. ...
Antibacterial properties of hLf1-11 peptide onto titanium surfaces: a comparison study between silanization and surface initiated polymerization
(ACS Publications, 2015)
Dental implant failure can be associated with infections that develop into peri-implantitis. In order to reduce biofilm formation, several strategies focusing on the use of antimicrobial peptides (AMPs) ...
Tuning mesenchymal stem cell response onto titanium-niobium-hafnium alloy by recombinant fibronectin fragments
(ACS Publications, 2016)
Since metallic biomaterials used for bone replacement possess low bioactivity, the use of cell adhesive moieties is a common strategy to improve cellular response onto these surfaces. In recent years, ...
Effect of the nature of the particles released from bone level dental implants: physicochemical and biological characterization
(MDPI, 2022)
The placement of bone–level dental implants can lead to the detachment of particles in the surrounding tissues due to friction with the cortical bone. In this study, 60 bone–level dental implants were ...
Effect of the acid-etching on grit-blasted dental implants to improve osseointegration: histomorphometric analysis of the bone-implant contact in the rabbit tibia model
(MDPI, 2021)
Previous studies have shown that the most reliable way to evaluate the success of an implant is by bone-to-implant contact (BIC). Recent techniques allow modifications to the implant surface that improve ...