Cerca
Ara mostrant els elements 1-10 de 248
SEM analysis and micro-CT evaluation of four dental implants after three different mechanical requests - in vitro study
(MDPI, 2024)
Statement of problem: Implant-supported rehabilitations are an increasingly frequent practice to replace lost teeth. Before clinical application, all implant components should demonstrate suitable ...
A non-interventional study documenting use and success of tissue level implants
(MDPI, 2020)
Numerous randomised controlled multicentric studies have investigated various responses to different treatment modalities with dental implants. These studies do not always show the results of daily ...
On-growth and In-growth osseointegration enhancement in PM porous Ti-scaffolds by two different bioactivation strategies: alkali thermochemical treatment and RGD Ppeptide coating
(MDPI, 2022)
A lack of primary stability and osteointegration in metallic implants may result in implant loosening and failure. Adding porosity to metallic implants reduces the stress shielding effect and improves ...
Comparison of shear bond strength and microleakage between activa™ bioactive restorative™ and bulk-fill composites—an In vitro study
(MDPI, 2023)
Bioactive materials have emerged as a promising alternative to conventional restorative materials as part of more conservative dentistry. The aim of this study was to evaluate and compare the shear bond ...
Influence of static navigation technique on the accuracy of autotransplanted teeth in surgically created sockets
(MDPI, 2022)
The aim of this study was to analyse and compare the position of single-rooted autotransplanted teeth using computer-aided SNT drilling and conventional freehand (FT) drilling, by comparing the planned ...
Do penicillin-allergic patients present a higher rate of implant failure?
(Quintessence Publishing, 2018)
Purpose: The aim of this clinical study was to determinate if patients allergic to penicillin present a higher incidence of dental implant failure compared with nonallergic patients. Materials and ...
Antimicrobial GL13K peptide coatings killed and ruptured the wall of streptococcus gordonii and prevented formation and growth of biofilms
(Public Library of Science, 2014)
Infection is one of the most prevalent causes for dental implant failure. We have developed a novel antimicrobial peptide coating on titanium by immobilizing the antimicrobial peptide GL13K. GL13K was ...
PLA-based mineral-doped scaffolds seeded with human periapical cyst-derived MSCs: a promising tool for regenerative healing in dentistry
(MDPI, 2019)
Human periapical cyst mesenchymal stem cells (hPCy-MSCs) are a newly discovered cell population innovatively collected from inflammatory periapical cysts. The use of this biological waste guarantees a ...
Influence of bone density, drill diameter, drilling speed, and irrigation on temperature changes during implant osteotomies: an in vitro study
(Springer Nature, 2021)
Objective: The aim of this in vitro study was to evaluate the influence of bone type, drill diameter, drilling speed, and irrigation on heat generation while performing osteotomy for dental implants. ...
Two different strategies to enhance osseointegration in porous titanium: inorganic thermo-chemical treatment versus organic coating by peptide adsorption
(MDPI, 2018)
In this study, highly-interconnected porous titanium implants were produced by powder sintering with different porous diameters and open interconnectivity. The actual foams were produced using high cost ...