Effect of different implant designs on strain and stress distribution under non-axial loading: a three-dimensional finite element analysis
Autor/a
Oliveira, Hélder
Ríos-Santos, José-Vicente
Sánchez Lasheras, Fernando
Ferreira Lemos, Bernardo
Gil Mur, Francisco Javier
Carvalho, Alexandrine
Fecha de publicación
2020ISSN
1660-4601
Resumen
Implant design evolved alongside the development of implant therapy. The purpose of this finite element analysis (FEA) study was to analyze the influence of different implant designs on the stress and strain distribution to the implants and surrounding bone. Three implant designs with the same length and diameter were used. The three-dimensional geometry of the bone was simulated with a cortical bone of three different thicknesses and two medullar bone densities: low density (150 Hounsfield units) and high density (850 Hounsfield units). A 30° oblique load of 150 N was applied to the implant restoration. Displacement and stress (von Mises) results were obtained for bone and dental implants. The strain and stress distributions to the bone were higher for the tissue-level implant for all types of bone. The maximum principal strain and stress decreased with an increase in cortical bone thickness for both cancellous bone densities. The distribution of the load was concentrated at the coronal portion of the bone and implants. All implants showed a good distribution of forces for non-axial loads, with higher forces concentrated at the crestal region of the bone–implant interface. Decrease in medullar bone density negatively affects the strain and stress produced by the implants.
Tipo de documento
Artículo
Versión del documento
Versión publicada
Lengua
Inglés
Materias (CDU)
616.3 - Patología del aparato digestivo. Odontología
Palabras clave
Implants dentals
Odontologia
Boca -- Cirurgia
Implantes dentales
Odontologia
Boca -- Cirugía
Dental implants
Odontology
Mouth -- Surgery
Páginas
17
Publicado por
MDPI
Colección
17;13
Publicado en
International Journal of Environmental Research and Public Health
Citación
Oliveira, Hélder; Brizuela Velasco, Aritza; Ríos-Santos, José-Vicente [et al.]. Effect of different implant designs on strain and stress distribution under non-axial loading: a three-dimensional finite element analysis. International Journal of Environmental Research and Public Health, 2020, 17(13), p. 1-17. Disponible en: <https://www.mdpi.com/1660-4601/17/13/4738>. Fecha de acceso: 28 jul. 2020. DOI: 10.3390/ijerph17134738
Este ítem aparece en la(s) siguiente(s) colección(ones)
- Ciències de la Salut [725]
Derechos
© 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).
Excepto si se señala otra cosa, la licencia del ítem se describe como http://creativecommons.org/licenses/by/4.0